How To Put Belt Back On Washing Machine
How To Put Belt Back On Washing Machine. In some cases, removing the back wall of. If your washing machine has an access panel at the back you will need to remove this as well as.
Assuming you got a little wheel (motor) big wheel (drum) put the belt on the motor offer the belt to the drum as the belt starts to feed on the pulley rotate the drum pulley to help the belt go on this is like putting the chain back on a bicycle wirecutterman january 2008 Look around the top rim of the drum to see if there’s a piece of fabric wedged in between the basket and the drum. Tension the belt by hand and install it on the pulley.
Put The Rear Panel Of Your Washing Machine Back On And Apply The Screws With Your Philips Screwdriver.
Move the appliance back against the wall. Plug the washer’s power cord back in. Wf860 household appliances, washing machines washing machine call assuming you got a little wheel (motor) big wheel (drum) put the belt on the motor offer the belt to the drum as the belt starts to feed on the pulley rotate the drum pulley to help the belt go on
Put The New Belt On The Motor Pulley, Placing It In The Same Place Where The Old One Was.
Use torque 20 drivers and loosen and remove all the screws that. Locate the pulley for the washing machine drive belt. Use blocks or books to prop up the washing machine enough not to crush any fingers.
Ease It To The Floor By Supporting The Falling Top Edge.
Reconnect the water supply hoses to the inlet ports. You will have noticed that the belt has grooves on it and these will go around the motor spindle, then feed the belt around the near side of the pulley ensuring the belt stays on the motor spindle. Together, slowly and carefully tip your washing machine over.
If The Belt Is Worn Or Damaged, You Can Replace The Belt Easily.
Look around the top rim of the drum to see if there’s a piece of fabric wedged in between the basket and the drum. Secure the hose by sliding the spring clamp into place. 5) remove the old belt.
Put The Drive Belt Central On The Motor Splines Offer The Belt To The Large Pulley Fed The Belt On You Will Come To A Point Where The Belt Seems To Short, At This Point Start To Turn The Large Pulley ,Keep Fingers Away From Edge The Belt Will Stretch And Jump On To The Pulley.( Like Fitting A Chain On A Bike)Give The Drum A Couple Of Turns To.
How to replace a belt on a front load washing machine step1. The next step is to remove the old belt completely. If your washing machine drum isn't turning then it could be the belt that has snapped and needs replacing.
Post a Comment for "How To Put Belt Back On Washing Machine"